Q#6591
13: GENERAL PURPOSE GRIPPERS 216-535-4848
For mounting:
1- Insert the square nut (A) in its seat on the "S 00" bracket 2- Insert the bracket into the groove 3- Insert the sensor into the bracket 4- Run the sensor until the lamp is on 5- Lock the bracket with the screw (B) but don't overtighten it
Sensors
The operating position can be checked by sensors (optional), that detect the magnet on the piston inside. Therefore, proximity near a large mass of ferromagnetic material or intense magnetic field may cause sensing trouble. CB... sensors are recommended for midstroke detection. Quick# Part# Signal Connection Price 6126 CB3N2-G PNP 3-wire sensor with M8 Connector $22.88 1794 CB3M2-G NPN 3-wire sensor with M8 Connector $22.90 (*) Purchase extension cable #6591 separate for these sensors. 6591 CFSM890325 3m 3-wire extension with M8 female connector $7.18
Parallel Gripper - PE
See Sensor Reference Guide on page 1010 for a complete list of compatible sensors.
Silicone Pads 3-Position Teachable Sensor 3D Printed Shroud Close/Open Port Flow Controls Not shown: Built-in 5/2 solenoid valve Contact: Cobots@EMIcorp.com
PLG-PRO Gripper Kit for Sawyer with PE-1640
717
Previous Page