Torque Rating Solenoid to Valve: 3.0 in. lbs. Use a Torx Screw Driver Torque Rating Valve to Base: 4.5 in. lbs. Use a Torx Screw Driver
18: VALVES & REGULATORS 216-535-4848
Connections to PLCs and Other Controls
The two (2) wires of each connector cable can be taken directly to the output terminals of a PLC or field bus module. If all outputs have a single common terminal, it will be necessary to use an intermediate terminal block with the commons linked. Connections outside enclosures may be IP67 protected, using the standard M8 or M12 connectors of a terminal box. For safety and standardization reasons, most machine builders now use 24VDC. This convergence towards only one voltage leads to a simpler system with a unique solenoid pilot. In order to cater to the man-machine dialog requirements, this solenoid pilot manual override is both multifunctional and adaptable to each stage, from the machine installation to its maintenance. The standard modules have solenoid pilots with multifunction manual overrides: Push-release function; Push-twist-lock function. Man-machine dialog is then complete, facilitating the commissioning of each machine subassembly. Later, when electrical controls are connected, the manual override may be adapted. Depending on the machine and its conditions of use, one may either: Keep complete multifunction manual overrides; Delete the lock capability by removing the locking stop; this will prevent the manual override from being left in the locked position; or Make the manual override completely inoperative when automatic controls take care of access for maintenance. An isolation fork is available for this operation.
Solenoid Pilot with Multifunction and Adaptable Manual Override
Multifunction Manual Override Manual Override Adaptations
1. Push -Release 2. Push -Twist - Lock 1. Remove Lock Capability 2. Manual Override is Totally Isolated
Locking Stop Isolation Fork
1039
Previous Page