SN... SS... SZ08 SZ12 SZ16 SZ20 SZ25 SZ32 SZ40 O-Ring 01x6 02.62 x 5.23 01.78 x 15.6 SN... SS...

OUT

PNP

OUT

NPN

Magneto-resistive

G H

EMIcorp.com 13: GENERAL PURPOSE GRIPPERS

Wide Angle Gripper - SZ

Sensors

The operating position can be checked by sensors (optional), that detect the magnet on the piston inside. Therefore a nearby big mass of ferromagnetic material or intense magnetic fields may cause sensing troubles. Quick# Part# Type Connection Price 3-wire, SS type 'C' slot magnetoresistive sensor 1882 SS4N225G PNP with lead, 2.5m long $27.20 1883 SS4M225G NPN with lead, 2.5m long $27.20 6282 SS3N203G PNP M8 male connector, 0.3m long $31.16 1884 SS3M203G NPN M8 male connector, 0.3m long $31.16 3-wire, 90 Lead exit, SN type 'C' slot magnetoresistive sensor 6278 SN4N225G PNP with lead, 2.5m long $27.20 6357 SN4M225G NPN with lead, 2.5m long $27.20 6277 SN3N203G PNP M8 male connector, 0.3m long $31.16 6356 SN3M203G NPN M8 male connector, 0.3m long $31.16 Note: M8 Extension cables Quick#'s 2582 & 2583 available on page 985.

Compressed air feeding

The compressed air feeding can be accomplished on the lateral air ports (P and R) with fittings and hoses (not supplied). Or it can be accomplished directly through the bottom air ports (G and H) by removing the plugs (E and F). Compressed air in P - H: gripper opening. Compressed air in R - G: gripper closing. The compressed air, must be filtered from 5 to 40 m. Maintain the medium selected at the start, lubricated or not, for the complete service life of the gripper. The pneumatic circuit must be pressurized progressively, to avoid uncontrolled movements.

See Sensor Reference Guide on page 1010 for a complete list of sensors for SZ Grippers.

684